| Customization: | Available |
|---|---|
| After-sales Service: | Yes |
| Warranty: | 2 Years |
|
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Model: TBS2204B Specifications | |
| Channels | 4 |
| Bandwidth | 200 MHz |
| Max Sample Rate | 2 GS/s - Half Channel 1 GS/s - All Channels |
| Record length | 5 M points |
| Vertical system analog channels | |
| Hardware bandwidth limits | 20 MHz |
| Input coupling | DC or AC |
| Input impedance | 1 MΩ ± 1 %, 13 pF ± 1.5 pF |
| Input sensitivity range | 1mV/div to 10 V/div |
| Vertical resolution | 8 bits |
| Maximum input voltage, 1 MΩ | 300 VRMS, Installation header II; with peaks ≤ ±450 V |
| Acquisition modes | |
| Sample | Acquire sampled values. |
| Peak Detect | Captures glitches as narrow as 3.5 ns at all sweep speeds. |
| Average | From 2 to 512 waveforms included in average. |
| Hi-Res | Averages multiple sample of one acquisition interval into one waveform point. |
| Roll | Scrolls waveforms right to left across the screen at sweep speeds slower than or equal to 40 ms/div. |
| Math modes | |
| All units | Ch 1 - Ch 2 Ch 2 - Ch 1 Ch 1 + Ch 2 Ch 1 X Ch 2 FFT |
| 4 channel units | Ch 3 - Ch 4 Ch 3 + Ch 4 Ch 4 - Ch 3 Ch 3 X Ch 4 |
| DC balance | ± (1 mV +0.1 div) |
| DC gain accuracy | ± 2% 10 V/div through 5 mV/div ± 3% typical 1 mV/div |
| DC voltage measurement accuracy average mode | |
| Average of > 16 waveforms | ±((DC Gain Accuracy) X |reading - (offset - position)| + Offset Accuracy + 0.11 div + 1 mV) |
| Delta Volts between any two averages of ≥16 waveforms acquired with the same oscilloscope setup and ambient conditions | ±(DC Gain Accuracy X |reading| + 0.08 div + 1.4 mV) |
| Vertical position range | ± 5 divisions |
| Vertical offset ranges | |
| Volts/Div setting | 1 MΩ, Input |
| 1 mV/Div to 50 mV/Div | ±1 V |
| 51 mV/div to 505 mV/div | ± 10 V |
| 510 mV/div to 10 V/div | ± 100 V |
| Analog bandwidth, DC coupled | |
| 200 MHz models | DC to >200 MHz |
| 100 MHz models | DC to ≥100 MHz |
| 70 MHz models | DC to ≥70 MHz |
| Common mode rejection ratio (CMRR), typical | 100:1 at 60 Hz, reducing to 10:1 with 50 MHz sine wave with equal Volts/div and coupling settings on each channel. |
| Horizontal system analog channels | |
| Maximum duration of time captured at highest sample rate (all channels) | 5 ms |
| Time base range | TBS220xB, TBS207xB, TBS210xB: 1 ns/div to 100 sec/div |
| Seconds division range | TBS207xB, TBS210xB, TBS220xB: 1 ns/div to 100 sec/div in a 1-2-4 sequence |
| Time-base delay time range | -15 divisions to 5000 s |
| Deskew range | ±100 ns |
| Time base accuracy | ±25 ppm over any ≥1 ms interval |
| Trigger system | |
| Trigger modes | Auto, Normal, and Single |
| Trigger holdoff range | 20 ns to 8 s |
| Trigger types | |
| Edge | Positive or negative slope on any channel. Coupling includes DC, HF reject, LF reject, and noise reject. |
| Pulse | width Trigger on width of positive or negative pulses that are >, <, =, or ≠ a specified period of time. |
| Runt | Trigger on a pulse that crosses one threshold but fails to cross a second threshold before crossing the first again. |
| Trigger | coupling analog channels DC, Noise Reject, High Freq Reject, Low Freq Reject |
| Trigger level ranges | Input channels: ± 4.90 divisions from center screen |
| Data storage | |
| Nonvolatile memory retention time, typical | No time limit for Front Panel Settings, saved waveforms, setups, and calibration constants |
| Real-Time clock | A programmable clock providing time in years, months, days, hours, minutes, and seconds |
| Waveform measurements | |
| Cursors | Time, amplitude, and screen |
| Automated measurements | 32, of which up to six can be displayed on-screen at any one time. Measurements include: Period, Frequency, Rise Time, Fall Time, Positive Duty Cycle, Negative Duty Cycle, Positive Pulse Width, Negative Pulse Width, Burst Width, Phase, Positive Overshoot, Negative Overshoot, Peak to Peak, Amplitude, High, Low, Max, Min, Mean, Cycle Mean, RMS, Cycle RMS, Positive Pulse Count, Negative Pulse Count, Rising Edge Count, Falling Edge Count, Area, Cycle Area, Delay FR, Delay FF, Delay FR, and Delay RR. |
| Gating | Isolate the specific occurrence within an acquisition to take measurements on, using either the screen, between waveform cursors or full record length. |
| Waveform math | |
| Arithmetic | Add, subtract, and multiply waveforms. |
| FFT | Spectral magnitude. Set FFT Vertical Scale to Linear RMS or dBV RMS, and FFT Window to Rectangular, Hamming, Hanning, or Blackman-Harris. |
| Remote control software | |
| Web page | Built-in web page enables remote control of horizontal and vertical scale, trigger settings, and measurements. Allows waveform and image save to USB flash drive. |
| Display system | |
| Display type | 9 inch (228 mm) wide format liquid crystal TFT color display. |
| Display resolution | 800 horizontal by 480 vertical displayed pixels (WVGA). |
| Waveform styles | Vectors, Variable Persistence, and Infinite Persistence. |
| Graticules | Grid, None. |
| Format | YT and XY |
| Input output ports | |
| USB 2.0 high-speed host port | Supports USB mass storage devices, Wi-Fi dongle, One port available on rear panel and one on front panel. |
| USB 2.0 device port | |
| USB 2.0 high-speed device port | |
| Device port | Rear-panel connector allows for communication/control of oscilloscope through USBTMC or GPIB with a TEK-USB-488 |
| Compatible USB-WIFI dongles | NETGEAR WNA1000M, WNA3100M, D-LINK DWA-131, TP-LINK TL-WN823N |
| LAN port (Ethernet) | RJ-45 connector, supports 10/100BASE-T |
| Probe compensator | |
| Amplitude | 5 V |
| Frequency | 1 kHz |
| Kensington-style lock | Kensington-style lock |
| Power source | |
| Power source voltage | 100 to 240 VAC RMS ±10% |
| Power source frequency | 47 Hz to 63 Hz (100 to 240 V) 360 Hz to 440 Hz (100 to 132 V |
| Power consumption | 80 W maximum |
| Physical characteristics | |
| Dimensions | |
| TBS2xx2B | Height: 174.9 mm (6.89 in) Width: 372.4 mm (14.66 in) Depth: 103.3 mm (4.07 in) |
| TBS2xx4B | Height: 201.5mm (7.93 in) Width: 412.8 mm (16.25 in) Depth: 128.1 mm (5.04 in) |
| Weight | |
| TBS2xx2B: 2.62 kg (5.8 lbs.), standalone instrument. 5.1 kg (11.2 lbs.), when packaged for domestic shipment. |
|
| TBS2xx4B: 4.17 kg (9.2 lbs.), stand-alone instrument. 7 kg (15.4 lbs.), when packaged for domestic shipment. |
|
| Cooling clearance | 50 mm (2 in) required on left side and rear of instrument. |
| EMC, environment, and safety | |
| Temperature | |
| Operating | 0 °C to +50 °C (+32 ºF to 122 ºF) |
| Nonoperating | -40 °C to +71 °C, (-40 ºF to 160 ºF) |
| Humidity | |
| Operating | 5% to 95% relative humidity (% RH) at up to +30° C 5% to 60% RH above +30° C up to +50° C non-condensing |
| Nonoperating | 5% to 95% RH (Relative Humidity) at up to +30° C 5% to 60% RH above +30° C up to +60° C non-condensing |
| Humidity | |
| Operating | 5% to 95% relative humidity (% RH) at up to +30 °C 5% to 60% RH above +30 °C up to +50 °C, noncondensing. |
| Nonoperating | 5% to 95% RH (Relative Humidity) at up to +30 °C 5% to 60% RH above +30 °C up to +60 °C, noncondensing. |
| Altitude | |
| Operating | Up to 3,000 meters (9,842 feet). |
| Non-Operating | Up to 12,000 meters (39,370 feet). Altitude is limited by possible damage to LCD at higher altitudes. This damage is independent of operation. |
| Regulatory | |
| Electromagnetic compatibility | EC Council Directive 2014/30/EU |
| Safety | UL61010-1, UL61010-2-030, CAN/CSA-C22.2 No. 61010.1, CAN/CSA-C22.2 No. 61010-2:030; complies with the Low Voltage Directive 2014/35/EU for Product Safety |
1. Are you a manufacturer or a trader?
Yes, we are both.
2. What products do you have?
We are focus on instruments and meters. Such as Mechanical / Optical /Power/ SafetyEnvironmental testing equipments and
some hardware tools amd eletronic components.
More infomation about business, please contact us we can send you catalog for reference.
3. Can i get a sample first?
Yes, we are pleased to send you sample to test the quality and market.
4. Can you do OEM for us?
Yes, OEM are welcome for us. Customers' brand, logo, label can be customized for the produets andcarton package, but based on a certain quantity.
5. What are your strengths?
We have a complete range of products covering low, medium and high-end markets in good price in Instruments field.
Fast Delivery, factory high quality and professional engineers to solve your problems.
){kind=link}